Table of Contents
Advertisement
play ISA adapter.
configured automatically by the Plug-and-Play BIOS or Windows 95.
If you install the WL-2400 wireless LAN adapter into a computer neither
with Microsoft Windows 95 nor the Plug-and-Play BIOS, you should
load plug-and-play configuration manager (such as Intel Plug and Play
Configuration Manager, CM) to configure the WL-2400 wireless LAN
adapter automatically.
program (also included in the WireFree WL-2400 Driver & Utility
diskette) to setup the adapter manually before the network driver or utility
is running.
WLJMP is an MS-DOS command. You can simply issue the command
in the DOS prompt:
WLJMP -irq <IRQ Number> -port <IO Port Address>
The <IRQ Number> can be 10, 11, or 12. The <IO Port Address> is
from 0x280 to 0xFFC0 stepped by 0x40, such as 0x280, 0x2C0, 0x300,
0x340, 0x380, 0x3C0, ..., 0xFFC0.
You should provide the IRQ Number and I/O Port Address manually
depend on the configuration of your computer. Wrong (conflicting) setting
may cause the system hung-up.
NOTE: If you had setup wrong IRQ or I/O-port parameters when issued WLJMP
command, or you want to change the parameter, you must power off your
computer and reboot your computer then issue WLJMP command again.
Otherwise, the IRQ and I/O-port parameters cannot be modified simply by
running WLJMP again.
The IRQ and I/O Port of the adapter will be
Otherwise, you should use the WLJMP.EXE
9
Advertisement
Table of Contents
