Table of Contents
Advertisement
The "Master Test Station" window contains the following status/ statistical information
during the Link Quality Test session:
¨
Slave / Test Address:
physical address will be displayed while performing Access Point loopback test.)
¨
Packet Sent:
¨
Packet Received:
¨
Elapsed Time:
¨
Signal level:
is calculated as the percentage of its signal level measurement relative to the full
signal level.
2. Act as Slave test station:
You can press [Start] button to start the slave test station. The "Slave Test Station"
window will be displayed after pressing [Start] button.
The "Slave Test Station" window) contains following status/statistical information during
the Link Quality Test session:
Fig4.9 Act as Master test station
The physical address of the destination slave test station. (Self
Total test packets have been sent.
Total responding packets have been received.
Total testing time.
The signal level when receiving last responding packet. The signal level
30
Advertisement
Table of Contents
