Understanding The Remote Control Unit - Teac SDB420 Owner's Manual

Understanding the Remote Control Unit

1 STANDBY
To switch between Operation and
Standby mode.
2 TV/STB
Not used
3 SUBTITLE (Red)
To select closed caption.
Note that closed caption may not always
work as the broadcaster may not provide
this service.
4 PAGE UP/DOWN
To move up or down a page in the
channel list.
5 SOUND (Yellow)
To select the sound track list in the current
channel.
6 VOLUME UP/DOWN
To increase or decrease the volume.
7 OK
To confirm your choice.
8 EXIT
To return to the normal viewing mode from
a menu.
9 TELETEXT
To navigate teletext pages.
10 JUMP
This key will jump between the 1st service
of each network.
Note : Your DVB receiver is capable of displaying teletext on screen since it has an
embedded teletext decoder.
**AUSTEXT only available from 7 digital
SDB420
11 MUTE
To enable or disable the audio.
12 NUMERIC BUTTONS
To select the channel and enter the
channel information and PIN Code.
13 EPG
To display the TV/Radio program guide.
14 INFORMATION (Green)
To display the program information box on
the screen.
15 PRE-CHANNEL (Blue)
To return to the previous channel.
16 CHANNEL UP/DOWN
To change channels up and down.
17 MENU
To display the Main Menu on the screen or
return to the previous menu.
18 TV/RADIO
Not used
19 ASPECT
To select your screen aspect ratio.
Press this button to toggle different modes.
20 EVENT
To select the extended event information of
the program.
21 M-View
To display multi angle view selection.
- 9 -
Digital Terrestrial Receiver