Tecsun PL-660 Operation Manual page 10

WORKING WITH STATION MEMORIES
METHOD 3: ATS (AUTO TUNING STORAGE)
FM ATS:
1. Fully extend the telescopic antenna
and press the [FM] button to select
FM band.
2. Press & hold the [FM] button with
"PRESET" flashing and the frequency
start running, then you can scan
and store the available stations
within the memories. When the
frequency stop running, it means
the ATS operation has been completed; you can rotate the
[TUNING] knob searching for those scanned and stored stations.
MW/LW ATS:
1. Press the [AM] button to select MW/LW band.
2. Press & hold the [AM] button for ATS MW or LW.
SW ATS:
Fully extend the telescopic antenna and press the SW [
button to select SW band. There are two modes for SW ATS tuning:
Mode A: Press & hold the [
meter bands
Mode B: Press & hold the [
present meter band only.
Notes:
1. During ATS process in FM, MW / LW or SW (mode A), pre-stored
radio stations will be replaced automatically by the new searched
stations.
2. With ATS in SW (mode B), those existing memories will not be
replaced; all the newly found radio stations would be stored in the
blank memories addresses.
3. If there is too many interference in you surrounding or many
mirror/blank station being stored during ATS, you should contract
the telescopic antenna (FM & SW) or rotate the radio (MW & LW)
for better location. You can also push the [ANT. GAIN] button to
the position "NORMAL" or "LOCAL" to restart ATS.
PL-660.....................................................................................9
] button to ATS the stations within all
] button to ATS the stations within
www.tecsunradios.com.au
SL EEP
0 1 2 3 4 5
PAGE
Ni-MH
Battery
MHz
FM
] or [
flashing
PRESET
]