Sanyo PLC-WXU30 Owner's Manual page 98

Chapter 2 Setup procedures
To use the projector via the networks, follow the setup procedures below.
STEP 1
Install the software on computers.
Install the software recorded in CD-ROM on each computer which will be operated.
Read following pages of this chapter to install.
Select Wired LAN or Wireless LAN then connect the
STEP 2
LAN and set the configuration.
Decide depending on the LAN environment.
Wired LAN............ Refer to "4. Wired LAN Configurations" (p.25–31).
Wireless LAN ....... Refer to "5. Wireless LAN Configurations" (p.33–42).
Detailed LAN configurations need to be done with a browser later.
First, complete the Wired or Wireless LAN connection between computers and
projectors, then start browser configurations.
STEP 3
Network Configuration has completed.
Follow each chapter to project an image and operate the projector.
Operate and manage the projector
Project an image on the computer
Project an image on a network server
16
"6. Basic setting and operation" (p.43–62).
"7. Controlling the projector" (p.63-84)
"Projector Power status and check" (p.64)
"Controls" (p.66)
"PC adjustment" (p.70)
"Setting up the projector" (p.71)
"Timer setting" (p.74)
"Projector information" (p.77)
"Multi-control" (p.79)
"8. Network capture functions" (p.85-108)
"Use of real time capture" (p.89)
"Use of rnetwork communication" (p.94)
"Moderator function" (p.103)
"Create the image files" (p.110).
"Create the programe files" (p.115).
"Project the image with network viewer function" (p.120)
"9. Network viewer functions" (p.109-126)