Top Control - Sanyo PLC-WXU30 Owner's Manual

Part Names and Functions

Top Control

ALARM indicator
Blinks red when informing the setting or battery
status (pp.58–59).
LAMP REPLACE indicator
Lights yellow when the projection lamp reaches its
end of life (pp.65, 71).
ON/STAND–BY button
Turn the projector on or off (pp.22–23).
INPUT button
Select an input source (pp.30–31, 40–41).
KEYSTONE button
Correct keystone distortion (pp.26, 48).
POINT (VOLUME +/–) buttons
–Select an item or adjust the value in the
On-Screen Menu (p.24).
–Pan the image in the Digital zoom + mode (p.39).
–Adjust the volume level (Point
SELECT button
–Execute the selected item (p.24).
–Expand or compress the image in the Digital zoom
mode (p.39).
12
WARNING indicator
–Lights red when the projector detects an abnormal
condition.
–Blinks red when the internal temperature of the
projector exceeds the operating range (pp.62, 71).
POWER indicator
–Lights red when the projector is in stand-by mode.
–Lights green during operations.
–Blinks green in the Power management mode
(p.52).
AUTO SETUP/CANCEL button
–Correct vertical keystone distortion and adjust
computer display parameters such as Fine sync.,
Total dots, and Picture position (pp.26, 47).
–Display the image in SD card or return to the
menu bar in Memory Viewer menu.
Refer to the owner's manual of "Network Set-up
and Operation" and owner's manual of Memory
viewer.
buttons) (p.27).
MENU button
Open or close the On-Screen Menu (p.24).