Configuring Security With The Projector - Sanyo PLC-WXU30 Owner's Manual

Chapter 5 Wireless LAN configurations

Configuring security with the projector

Configure security with the projector by following the steps below.
After configuring the network in "5. Wireless LAN Configurations" (p.33-42), select "Next" in the LAN
setting screen and press SELECT button. The security configuration screen appears. Refer to "6. Basic
setting and operation"
WEP configuration screen
Use the Point buttons to select the security type. To disable the security, select "Disable. "
Use the Point buttons to move among the items; use the Point
This projector provides the following security options. Use optimum security option on your network
environment.
WEP64(40)bit Open
WEP64(40)bit Share
WEP128(104)bit Open
WEP128(104)bit Share
WPA-PSK(TKIP)
WPA2-PSK(AES)
Notes when entering characters:
The "¥" symbol is displayed as "\" when the ASCII key is used. The " " symbol is treated as a character
by the ASCII key, but it is not interpreted as a character by the HEX key. In HEX, the " " symbol is
displayed in red and setting is denied.
You can not set all the characters with the " " symbol. This will be considered as no operation.
ASCII key characters : Space - 0 to 9 A to Z a to z ! " # $ % & ' ( ) * + , . / : ; < = > ? @ [ ¥ ] ^ _ ` { | } ~
HEX key characters : 0 to 9 a to f
36
"Configuring wireless LAN setting and security setting" (p.53) as well.
buttons to adjust settings.