Adjusting Anti-Scalp Rollers - Toro 74161TE Operator's Manual

Figure 22
1. Height-of-cut lever
2. Clevis pin
5. Lower height-of-cut lever onto clevis pin.

Adjusting Anti-Scalp Rollers

Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp rollers.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting height-of-cut remove nut and washer
while holding stud with wrench (Fig. 23).
Note: Do not remove the wheel nut and washer (Fig. 23).
4. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 23).
5. Reinstall the stud nut and washer (Fig. 23).
6. Repeat adjustment on other gage wheels.
1
2
3
m–4122
3. Hairpin cotter
25
4
3
2
Figure 23
1. Gage wheel
2. Stud
3. Washer
Center Rollers
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting height-of-cut, remove bolt and nut
(Fig. 24).
4. Select hole so gage wheel is positioned to the nearest
corresponding height-of-cut desired (Fig. 24).
Note: Do not adjust rollers to support the deck.
5. Reinstall the bolt, center rollers and nut (Fig. 24).
3
1
Figure 24
1. Center rollers and spacer
2. Nut
1
5
m–4167
4. Nut
5. Wheel nut and washer.
Do not remove.
2
m–4124
3. Bolt