Table of Contents
Advertisement
Controls
Become familiar with all the controls (Fig. 7) before you
start the engine and operate the machine.
8
2
7
4
5
10
Figure 7
1. Ignition switch
2. Motion control lever
3. Parking brake lever
4. Throttle
5. Choke
Using the Hour Meter
The hour meter records the number of hours the engine
has operated. It operates when the engine is running. Use
these times for scheduling regular maintenance.
Figure 8
1. Hour meter
Switching the Fuel Tanks
The fuel shut off valve is located under the seat.
1
8
2
3
6
9
m–4200
6. Power take off (PTO)
7. Height-of-cut lever
8. Fuel cap
9. Hourmeter
10. Fuel shut-off valve
1
m–4202
The unit has two fuel tanks. One tank is on the left side
and one on the right side. Each tank connects to the fuel
shut off valve in the control panel. From there a common
fuel line leads to the engine (Fig. 7).
To use the left side fuel tank rotate the fuel shut off valve
to the LH, lefthand location. To use the right side fuel
tank rotate the fuel shut off valve to the RH, righthand
location (Fig. 9).
Close fuel shut off valve before transporting or storing
machine.
1. Shut-off valve
Operating the Parking Brake
Always set the parking brake when you stop the machine
or leave it unattended.
Important
Do not park on slopes unless wheels are
chocked or blocked.
Setting the Parking Brake
1. Move the motion control levers (Fig. 7) out to the
neutral lock position.
2. Pull back and up on the parking brake lever to set the
parking brake (Fig. 10). The parking brake lever
should stay firmly in the engaged position.
Releasing the Parking Brake
1. Push forward and down on the parking brake lever to
release the parking brake (Fig. 10). The parking brake
is disengaged.
18
1
Figure 9
Advertisement
Table of Contents
