Using Other Media; Xqd Memory Cards - Sony PMW-150 Operating Instructions Manual

To restore the hard disk
Select "Execute" via the up/down/left/right
buttons or the jog dial, then press the SEL/
SET button or the jog dial.
During restoration, an in-progress message and
status bar (%) are displayed, and the ACCESS
lamp is lit in red.
When restoration is completed, a completion
message is displayed for three seconds.
If restoration fails
• A PHU-220R on which an error occurred may
become usable again through reformatting.
• In some cases, only parts of clips cannot be
restored. Playback of the restored clips becomes
possible again.
26

Using Other Media

Using Other Media

XQD Memory Cards

By using an optional QDA-EX1 Media Adaptor,
you can insert an XQD memory card into the SxS
memory card slot and use it instead of an SxS
memory card.
Usable XQD memory cards
QD-H16, QD-H32 (as of March 2012)
For details on using a QDA-EX1 Media Adaptor,
refer to the instruction manual supplied with it.
Notes
• High-speed playback (page 13) may not be properly
achieved with an XQD memory card.
• Slow Motion recording by the Slow & Quick Motion
recording function (page 47) cannot be made with an
XQD memory card.
• Not all XQD memory cards are guaranteed to work
with this camcorder. For compatible memory cards,
contact your dealer.
Formatting
When you use an XQD memory card with this
camcorder, formatting is required.
An XQD memory card to be used with this
camcorder must be formatted using the format
function of this camcorder.
It is also necessary to format an XQD memory
card for use if a caution message is displayed
when you mount the XQD memory card.
For an XQD memory card that was formatted
with another system unsupported by this
camcorder, the message "Unsupported File
System" is displayed on the LCD monitor/EVF
screen.
Format the XQD memory card as instructed
below.
To execute formatting
Using "Format Media" (page 93) in the
OTHERS menu, specify "Media(A)" (slot
A) or "Media(B)" (slot B), then select
"Execute."
An in-progress message and status bar (%) are
displayed, and the ACCESS lamp lights in red.
When formatting is completed, a completion
message is displayed for three seconds.