Setting The Side-To-Side Leveling - Toro 74191 Operator's Manual

Maintenance

Setting the Side-to-Side Leveling

1. Check the tire pressure on both deck and traction
unit.
2. Position the blades side-to-side (Fig.63 ).
Measure at "A" and "B" locations (Fig. 63) from
a level surface to the cutting edge of blade tips
(Fig.64).
3. The difference between measurements "A" and
"B" should be no more than 1/4" (6 mm).
Figure 63
Figure 64
56
4. To change the side-to-side leveling, remove the
retaining ring and move the thrust washers on
one castor wheel fork only. Move the thrust
washers from the top of the carrier frame
mounting tube to the bottom to raise the
corresponding side of the mower. Move the
thrust washers from the bottom of the mounting
tube to the top to lower the corresponding side of
the mower. (Fig. 33).
5. Recheck the front-to-rear pitch of the cutting
unit.
m–3372
m–3372