Install Recycler Baffles; Recycler Operation - Toro 74191 Operator's Manual

Install Recycler Baffles

1. Tilt mower into the vertical position, refer to;
Tilting the Mower, page 27.
2. Remove cap screws, left and right bagger baffles
locknuts, carriage bolts, and left and right
discharge baffles from the mower (Fig. 7).
Note: Save all hardware for use when
installing bagger.
3. Locate the left and right Recycler baffles inside
mower and secure with (6) 1/4–20 x 3/4"
(19 mm) cap screws, through from the bottom of
mower, washers, (4) 1/4"–20 retained nuts and
1/4–20 locknuts (Fig. 5).
3
Figure 5
1. Recycler baffle
2. Cap Screw
1
2
4
3. Retainer Nut
4. Washer (.344x.688)

Recycler Operation

When operating the mower with Recycler baffles
installed you must disengage the blower drive belt.
1. Stop the engine, remove the key and disconnect
the spark plug wire(s) from the spark plug(s).
2. Remove hairpin cotter and clevis pin from idler
arm (Fig. 6).
3. Push up on the spring loaded idler arm, behind
PTO (power take off) gearbox, to relax pressure
on blower belt (Fig. 6).
4. Align hole in idler arm with slot in frame and
insert clevis pin. Secure with hairpin cotter to
hold in position.
4
Figure 6
1. Idler arm
2. Frame slot
Assembly
2
3
1
3. Clevis pin
4. Hairpin cotter
17