Stopping The Machine; Positioning The Seat - Toro 74191 Operator's Manual

Backward
1. Release the parking brake; refer to Setting the
Parking Brake, page 20.
2. To go backward, slowly pull the motion control
levers rearward (Fig. 9).
To go straight, move both motion control levers the
same distance (Fig. 9).
To turn move the motion control lever toward neutral,
on the side you want to turn toward (Fig. 9).
To slow or stop move the motion control levers to
neutral.

Stopping the Machine

To stop the machine, move the motion control levers
to neutral, disengage the power take off (PTO), and
turn the ignition key to "OFF" to stop the engine.
Also set the parking brake when you leave the
machine; refer to Setting the Parking Brake, page 20.
Remember to remove the key from the ignition
switch.
POTENTIAL HAZARD
Someone could move or attempt to operate
the tractor while it is unattended.
WHAT CAN HAPPEN
Children or bystanders may be injured if
they use the tractor.
HOW TO AVOID THE HAZARD
Always remove the ignition key and set the
parking brake when leaving the machine,
even if just for a few minutes.

Positioning the Seat

The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable.
1. To adjust, remove the locknut and washer, and
tip seat forward (Fig. 10).
1
2
3
Figure 10
1. Locknut
2. Washer
2. Loosen the seat mounting bolts slide seat to the
desired position in the adjusting slots and tighten
the mounting bolts (Fig. 11).
3. Lower seat and secure with washer and locknut
(Fig. 10).
2
Figure 11
1. Adjustment slot
2. Mounting bolt
Operation
m–3767
3. Seat base
1
m–3280
1200
25