Assembly
Install Castor Wheel
1.
Remove nut, washers, spacer and axle shaft from
fork (Fig. 1).
2.
Jack up rear of unit and install rear wheel into
castor fork (Fig. 1).
3.
Place wheel with spacer installed and washers
between fork and slide bolt through bearings
(Fig. 1).
4.
Secure bolt with 1/2" locknut (Fig. 1).
5.
Torque nut to 75 ft–lb (55 N m).
6.
Grease castor wheel bearings (Fig. 1).
Figure 1
1. Wheel assembly
2. Bolt 1/2–13 x 9" (227 mm)
3. Washer 1/2" (13 mm)
14
m–3227
4. Spacer
5. Locknut 1/2"
Check Tire Pressure
Check the air pressure in all tires: refer to Tire
Pressure in Maintenance section on page 42.
Secure PTO Cover
To lower mower refer to: Tilting the Mower in
Operation section on page 27.