Dumping The Hopper - Toro 74191 Operator's Manual

Operation
To Lower Mower
1. Pull out latch pins and rotate into notch to hold
in the open position (Fig. 14).
2. Standing in front of the mower, pull forward on
front and lower mower (Fig. 15).
3. Rotate latch pins into released position and lift
on side of carrier frame until latch pin engages
(Fig. 14). Repeat on the other side.
4. Secure PTO cover down with 5/16–18 x 7/8"
(11 mm) shoulder bolt and 5/16" flange nut
(Fig. 16).
Figure 16
1. PTO cover
2. Shoulder bolt
5/16–18 x 7/8" (11 mm)
28
3
1
2
3. Flange nut 5/16"

Dumping the Hopper

The hopper is equipped with a "hopper full" sensor
that checks for a full condition. When the alarm
buzzer sounds the hopper needs to be emptied.
1. Locate the traction unit so the hopper door is
located where you want to dump the clippings.
2. Move the power take off (PTO) switch to off,
move the traction controls to neutral and set the
parking brake.
IMPORTANT: The hopper is interlocked
with the engine ignition and the engine will
stop if these steps are not followed before
dumping the hopper or getting out of the seat.
3. Unhook the door latches on the rear sides and
the hopper latch on the front left side of the
hopper (Fig. 17).
4. Lift up on the hopper at the lower front and
dump the clippings (Fig. 17).
2
Figure 17
1. Door latch
5. Lower the hopper and secure the door latches on
the rear sides and the hopper latch on the front
left side of the hopper (Fig. 17).
IMPORTANT: Front left latch must be
secured to prevent hopper from accidently
tilting during transport.
1
2. Hopper latch