Setting The Side-To-Side Leveling - Toro 30149 Operator's Manual

Note: Move the thrust washers from the top of the
carrier frame mounting tube to the bottom to raise the
front of the mower. Move the thrust washers from the
bottom of the mounting tube to the top to lower the
front of the mower (Fig. 21).
2
3
Figure 21
1. Thrust washers (locate as
required)
2. Carrier frame mounting
tube
5. Check the side-to-side leveling of the cutting unit.
1
1
3. Castor wheel fork
14

Setting the Side-to-Side Leveling

1. Check the tire pressure.
2. Position the blades side-to-side (Fig. 22).
Figure 22
Note: Measure at locations A and B (Fig. 22) from a
level surface to the cutting edge of blades (Fig. 23).
Figure 23
3. The difference between measurements A and B should
be no more than 1/4 inch (6 mm).
4. To change the side-to-side leveling, move the thrust
washers on one castor wheel fork only.
Note: Move the thrust washers from the top of the
carrier frame mounting tube to the bottom to raise the
corresponding side of the mower. Move the thrust
washers from the bottom of the mounting tube to the
top to lower the corresponding side of the mower.
(Fig. 21).
5. Check the front-to-rear pitch of the cutting unit.
m–1078
m–2550