Entering A Pre-Programming Code; Learning A Pre-Programming Code - Onkyo TX-SR600 Instruction Manual

Entering a pre-programming code

The remote controller has three learning functions. One is entering
the pre-programmed code for a remote controller of another
manufacturer. Another is the normal learning function that enables
the remote controller to learn the codes directly from other remote
controllers (see page 70). And the last is a macro learning function
that enables you to program a series of operations into the remote
controller so that the operations can all be performed at once by
pressing one button (see page 73).
DISPLAY
Caution:
With some brand's components, some buttons may not work
correctly. In this case, program the command directly from the other
remote controller normally (see page 70).

Learning a pre-programming code

By entering a pre-programming code, you can have the RC-482M/
480M remote controller operate a component made by another
manufacturer. The buttons that are used for operation are given on
the next page.
1. Find the 3-digit number listed for the manufacturer
name of the component that you want to operate in the
table on the next page.
2. Turn on the component that you want to operate (i.e.
SEND/LEARN
indicator DVD, satellite tuner, or television).
3. While holding down the MODE button on the RC-482M/
480M that you want to program, press the DISPLAY
button, and then release both buttons.
Buttons that
The SEND/LEARN indicator lights when the MODE button is
can be pre-
pressed and turns off when the DISPLAY button is pressed.
programmed
When the indicator turns off, release both buttons. The SEND/
LEARN indicator lights again.
VOL
4. Within 30 seconds, enter the 3-digit code number.
The SEND/LEARN indicator slowly flashes twice. If the SEND/
LEARN indicator quickly flashes three times, then either a
mistaken 3-digit code was entered or an incorrect operation was
performed. If this occurs, return to step 3.
5. Press the button that you programmed and check if
the system operates correctly.
• If the component does not operate properly, return to step 3
• If it still does not operate properly, program the command
Numeric keys
When entering the code of Onkyo DVD players:
There are three SETTING numbers. Choose the SETTING number
according to how you will be using the DVD player.
No. 601/613: These codes are for operating the Onkyo DVD player
by pointing the remote controller directly at it, either because it does
not have an
an
613.
No. 600: This code is for Onkyo DVD players that have an
terminal that you are connecting to the TX-SR700/700E/600/600E
with an
the remote controller at the remote control sensor on the TX-SR700/
700E/600/600E. You do not need to enter this code because it is
factory preset. However, if the code has been changed to 601 or 613,
then you will need to change it back to 600.
and repeat the steps above.
directly from the other remote controller normally (see page
70).
terminal, or it does but you are not connecting it with
cable. First enter 601 and if it does not operate properly, enter
cable. You will then operate the DVD player by pointing
67