Onkyo TX-SR600 Instruction Manual page 10

Front panel facilities
Input source buttons (DVD, VIDEO 1–4, TAPE,
TUNER, PHONO (TX-SR700/700E only), and CD)
[44, 45, 53]
TX-SR600/600E:
These buttons are used to select the input source.
TX-SR700/700E:
Press these buttons to select the input source for the main zone.
To select the input source for the remote zone (Zone 2) or recording
out (Rec Out), first press the ZONE 2 or REC OUT button, and then
press the desired input source button. The input channel with its
indicator lit red is output to REC OUT and the one with its indicator
lit green is output to ZONE 2.
AUDIO SELECTOR button [47]
Press to select the type of audio input signal.
PURE AUDIO button and indicator (TX-SR700/700E
only) [49, 51]
Press to select the Pure Audio mode.
The PURE AUDIO indicator lights during pure audio playback.
PHONES jack [47]
This is a standard stereo jack for connecting stereo headphones.
REC OUT, ZONE 2, OFF, LEVEL
ZONE 2 indicator (TX-SR700/700E only) [60, 61]
The REC OUT and ZONE 2 buttons allow you to use the TX-SR700/
700E to output to a remote zone (Zone 2) or to another component
for recording (Rec Out). Press the REC OUT button to output the
audio and video signals to a recording component for recording.
Press the ZONE 2 button to enjoy the output from the TX-SR700/
700E in a different room, which is referred to as the remote zone
(Zone 2). When either button is pressed, the currently selected input
source for recording or outputting to the remote zone is displayed in
the front panel display. If "SOURCE" is displayed, then the same
input source as that selected for the main zone will be output.
To select an input source, press the desired button (REC OUT or
ZONE 2) and then press one of the input source button within 5
seconds. That source will be output for recording or viewing in the
remote zone.
To set the output to the source channel, press the desired button
(REC OUT or ZONE 2) twice in succession. To turn off the output,
press the OFF button. The ZONE 2 indicator lights when a signal is
output to the remote zone (Zone 2). When the ZONE 2 indicator is
off, then either output to the remote zone is turned off or Rec Out is
selected. Press the LEVEL
adjusting the volume in the remote zone (Zone 2).
Note:
The Rec Out and Zone 2 buttons use the same circuit and therefore
cannot be used at the same time. When REC OUT is selected,
nothing is output to Zone 2. When ZONE 2 is selected, REC OUT is
automatically fixed to SOURCE.
SPEAKERS A/B buttons (TX-SR600/600E only) [45]
Press these buttons to turn on and off speakers systems A and B.
10
/ buttons, and
/ buttons to enter the mode for