Operating Components Not Reached By The Remote Controller Signals (Ir In); Only); If The Remote Controller Signal Does Not Reach The Tx-Sr700/700E Remote Sensor - Onkyo TX-SR600 Instruction Manual

Operating components not reached by the remote
controller signals (IR IN)
In order to use the remote controller to control the TX-SR700/
700E from a remote location, you will need to prepare a multi-
room kit (sold separately) such as one of those given below:
• Onkyo's Multi-Room System kit (IR Remote Controller
Extension System)
• Multiroom A/V distribution and control system such as those
from Niles ® and Xantech
If the remote controller signal does not reach the
TX-SR700/700E remote sensor
If the TX-SR700/700E is located inside a cabinet or other enclosure
where the infrared rays from the remote controller cannot enter, then
operation with the remote controller will not be possible. In such a
case, it will be necessary to install a remote sensor at a location
outside of the cabinet where the infrared rays from the controller can
reach.
With this connection, select "Main" at "Preference" → "IR IN
Position" (see page 56).
Connecting
block
IR IN
TX-SR700
/700E
In the
cabinet
The IR IN input allows you to control the TX-SR700/700E from the
remote zone (Zone 2) with the remote controller even though the
remote zone may be on the other side of the building from the main
zone. The diagram below shows how to make the proper connections
for the remote zone.
With this connection, select "Zone 2" at "Preference" → "IR IN
Position" (see page 56).
To IR IN
TX-SR700/700E
Connecting
block
Main room
22
®
IR Receiver
Remote Controller
: Signal flow
IR Receiver
Remote controller
Zone 2 room
: Signal flow
(TX-SR700/700E only)
Make the connections as shown below. Do not plug in any
equipment to the power outlet until all the connections are complete.
Mini plug cable
From connecting block
REMOTE
CONTROL
ZONE 2
12 V
TRIGGER
OUT
IR
IN
TX-SR700/700E