Remote Control Unit - Samsung DVD-HR735 Instruction Manual

HDMI output Jitter
Check your TV system setup
Checkpoint 1
correctly.
Please refer to the user's manual of
Checkpoint 2
your TV.

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote
Checkpoint 1
control sensor on your HDD & DVD
RECORDER. Allow for proper
distance. Remove obstacles between
your HDD & DVD RECORDER and
the remote control.
Check whether the batteries are
Checkpoint 2
drained.
Check the TV/DVD selection button
Checkpoint 3
setting.
Check whether TV control button is
Checkpoint 4
selected or not.
124 - English
Downloaded From DvDPlayer-Manual.com Samsung Manuals
Other
I forgot my password for parental supervision.
Checkpoint 1
Press and hold the PROG(
buttons on the front panel of the
Recorder for more than 5 seconds
with no disc in the unit. All settings
including the password will revert to
the factory settings. Do not use this
unless absolutely necessary.
(Note that this function is possible
only when no disc is inserted.)
Is it possible to change a subtitle and an audio
signal on a recorded disc?
A recorded disc is played with only
Checkpoint 1
the subtitle and the audio signal
which were selected during recording.
Other problems.
Read the table of contents and then
Checkpoint 1
find and read the section describing
your problem, follow the instructions
given.
Plug your HDD &DVD RECORDER
Checkpoint 2
off and on.
If the problem still persists, contact a
Checkpoint 3
nearby Samsung service centre.
)