Table of Contents
Advertisement
Audio Selector
You can set priorities of audio output when there are both
digital and analog inputs.
■
Audio Selector
ARC:
The audio signal from your TV tuner can be sent to
the HDMI OUT of the AV receiver.
With this selection the TV's audio can be automati-
cally selected as a priority among other assignments.
HDMI:
This can be selected when HDMI IN has been
assigned as an input source. If both HDMI (HDMI
IN) and digital audio inputs (COAXIAL IN or OPTI-
CAL IN) have been assigned, HDMI input is auto-
matically selected as a priority.
COAX:
This can be selected when COAXIAL IN has been
assigned as an input source. If both coaxial and opti-
cal inputs have been assigned, coaxial input is auto-
matically selected as a priority.
OPT:
This can be selected when OPTICAL IN has been
assigned as an input source. If both coaxial and opti-
cal inputs have been assigned, optical input is auto-
matically selected as a priority.
Analog:
The AV receiver always outputs analog signals.
Note
• The setting is stored individually for each input selector.
• This setting can be made only for the input source that is
assigned as HDMI IN, COAXIAL IN, or OPTICAL IN.
*1
You can select "ARC" if you select the TV/CD input selector.
But you cannot select it if you've selected "Off" in the "Audio
Return Channel" setting
En
54
*1
(➔
52).
Setting the Incoming Digital Signal (Fixed
Mode)
By pressing ENTER while selecting "HDMI", "COAX",
"OPT" in the "Audio Selector", you can specify the input
signal in the Fixed Mode. Pressing ENTER again allows
you to return to the "Audio Selector" setting.
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the follow-
ing issues when playing PCM or DTS material, you can
manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing a
DTS CD, try setting the format to DTS.
Auto:
The format is detected automatically. If no digital
input signal is present, the corresponding analog
input is used instead.
PCM:
Only 2-channel PCM format input signals will be
heard. If the input signal is not PCM, the PCM indi-
cator will flash and noise may also be produced.
DTS:
Only DTS (but not DTS-HD) format input signals
will be heard. If the input signal is not DTS, the DTS
indicator will flash and there will be no sound.
Note
• The setting is stored individually for each input selector.
• The setting will be reset to "Auto" when you change the setting
54).
in the "Audio Selector"
(➔
Adjusting the Bass & Treble
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio
or THX listening mode is selected.
and Asian models)
1
Press TONE on the AV receiver repeatedly to
select either "Bass" or "Treble".
2
Use TONE LEVEL +/– on the AV receiver to
adjust.
■
Bass
■
Treble
See "Bass" and "Treble" in "Tone Control Settings"
52).
(➔
Note
• To bypass the bass and treble tone circuits, select the Direct, Pure
Audio (European, Australian and Asian models) or THX lis-
tening mode.
• This procedure can also be performed on the remote controller
by using the Home menu
(➔
(European, Australian
24).
Hide quick links:
Advertisement
Table of Contents
