Turntable Motor Removal - Electrolux EI30SM55JB Technical & Service Manual

15. Remove the two (2) screws holding the fan motor
to the fan duct.
16. Now, the fan motor is free.
INSTALLATION
1. Install the fan motor to the fan duct with the two (2)
screws.
2. Install the fan blade to the fan motor shaft according
to the following procedure.
3. Hold the center of the bracket which supports the
shaft of the fan motor on the flat table.
4. Apply the screw locktight into the hole (for shaft) of
the fan blade.
5. Install the fan blade to the shaft of fan motor by
pushing the fan blade with a small, light weight, ball
peen hammer or rubber mallet.
* Do not hit the fan blade strongly when installed
because the bracket may be disfigured.
* Make sure that the fan blade rotates smooth after
installation.
* Make sure that the axis of the shaft is not
slanted.
6. Install the fan duct to the oven cavity, base plate right
and hood duct with the three (3) screws.
7. Connect the high voltage wire leads with high voltage
rectifier from the magnetron, referring to the pictorial
diagram.
8. Connect filament lead of the transformer from high
voltage capacitor, referring to the pictorial diagram.
9. Connect high voltage wire from capacitor, referring to
the pictorial diagram.
10. Connect the wire leads to the fan motor, referring to
the pictorial diagram.
11. Re-install the outer case.
Component Teardown and Testing
Figure 4-5. Fan Assembly Removal

Turntable Motor Removal

1. Disconnect the power supply cord and then remove
outer case.
2. Open the door and block it open.
3. Remove the three (3) screws holding the deflector to
the cavity face plate.
4. Remove the four (4) screws holding the base cover to
the oven cavity.
5. Remove the base cover from the oven cavity by
pulling down and moving to the left slightly.
6. Disconnect the wire leads from the turntable motor.
7. Remove one (1) screw holding turntable motor to the
oven cavity.
8. Now the turntable motor is free.
4-7