Door Disassembly; Cook Top Lamp Socket Removal - Electrolux EI30SM55JB Technical & Service Manual

Door Disassembly

1. Disconnect the power supply cord and remove the
oven from wall and remove outer case. (Refer to
procedure of "Removal of Oven from Wall" and "Outer
case Removal")
2. Open the door and block it open.
3. Discharge high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
4. Remove the hood louver from the oven cavity. (Refer
to the procedure of "Hood Louver Removal".)
5. Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
6. Place door assembly on a soft cloth with latches
facing up.
As the engaging part of choke cover and door
frame are provided at 16 places, do not force any
particular part.
CHOKE COVER
7. Insert a putty knife (thickness of about 0.5mm) into
the gap A between the choke cover and door stopper
and between the choke cover and the door frame as
shown Figure 4-9 to free engaging parts.
8. Pry the choke cover by inserting a putty knife in order
shown in Figure 4-9.
9. Now choke cover is free from door panel and door
frame.
LATCH SPRING, LATCH HEAD AND DOOR PANEL
10. Release the latch spring from the tab of the latch
head and tab of the door panel.
11. Release the latch head from the door panel.
12. Now, the latch spring, latch head and door panel are
free.
Component Teardown and Testing
DOOR FRAME
13. Remove eight (8) screws holding the door panel to
the door frame assembly.
14. Release the door frame assembly from the door
panel.
It is easier to release the engaging parts of the
upper or lower door hinge pin side at first.
15. Now, door frame assembly is free.
Figure 4-9. Choke Cover

Cook Top Lamp Socket Removal

1. Disconnect the power supply cord.
2 Remove the three (3) screws holding the deflector to
the base cover.
3. Remove the one (1) screw holding the base cover to
the oven cavity back plate.
4. Remove the four (4) screws holding the base cover to
the outer case cabinet.
5. Remove the three (3) screws holding the base cover
to the oven cavity base plate.
6. Pull down and slide to left the base cover. Then
remove the base cover from the cavity back plate.
7. Remove the one (1) screw holding the lamp mounting
angle.
8. Remove the lamp mounting angle from the oven
cavity face plate.
9. Disconnect the wire leads from the lamp socket.
10. Remove the two (2) screws holding the lamp socket
from the lamp mounting angle.
11. Now, the lamp socket is free.
4-13