Special Instructions For The Turntable Support And Turntable Glass Tray - Electrolux EI30SM55JB Technical & Service Manual

Special Instructions for the
Turntable Support and Turntable
Glass Tray
Make sure to remove the tape at the turntable
support before operation. Because the tape is
attached when the product is shipped from the
factory.
Remove this tape before operation
Figure 1-5. Turntable Support Installation
Read carefully before installing the turntable glass tray
and turtable support for proper operation. Improper
installation will cause dragging noise and erratic turntable
glass rotation.
1. Place the turntable support to the turntable motor
shaft (Inside oven bottom plate hole). And make
sure the center of turntable support is inserted to
turntable motor shaft.
2. The turntable glass tray should be set so all three
rollers of the turntable support contact to the flat
surface of the turntable glass tray.
Oven Bottom Plate Hole
CORRECT
Flat Surface of Turntable Glass Tray
Back
View
Roller of Turntable Support
Flat Surface of Turntable Glass Tray
Side
View
Roller of Turntable Support
1-11
Basic Information
Turntable Support
Figure 1-5a.
Figure 1-5b.
Turntable Support
Figure 1-5c.
WRONG
Flat Surface of Turntable Glass Tray
Flat Surface of Turntable Glass Tray
Out of Flat Surface
Out of Flat Surface