Turntable Motor Removal - Electrolux EI24MO45IBA Technical & Service Manual

Installation
1. Remove remaining adhesive on the control panel
frame surfaces with a soft cloth soaked in alcohol.
2. Make sure that the VFD (Vacuum Fluorescent
Display) is in good condition.
3. Remove the backing paper from the new graphic
sheet.
4. Adjust the upper edge and left edge of the graphic
sheet to the large depression on the surface of the
control panel frame.
5. Attach the graphic sheet to the control panel frame by
rubbing with a soft cloth not to scratch.
6. Reinstall the control panel frame to the oven.
NOTE: Do not touch the contact surface of the ribbon
cable (edge).
Figure 4-4. Key Unit Replacement
Component Teardown and Testing

Turntable Motor Removal

1. Disconnect the power supply cord.
2. Remove turntable and turntable support from oven
cavity.
3. Lay the oven on it's backside. Remove the turntable
motor cover by snipping off the material in four
corners.
4. Where the corners have been snipped off bend
corner areas flat. No sharp edges must be evident
after removal of the turntable motor cover.
5. Disconnect wire leads from turntable motor.
(See "Positive lock connector removal")
6. Remove one (1) screw holding turntable motor to
oven cavity.
7. Now the turntable motor is free.
8. After replacement use the one (1) screw to fit the
turntable motor cover.
4-5