Adjusting The Handle Height - Toro 30074 Operator's Manual

Figure 14
48 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
Figure 15
48 inch Mower Decks
1. Mower deck
2. Bolt
3. Spacer
4. Anti-scalp rollers
5. Nut
4. Bushing
5. Anti-scalp rollers
6. Nut
36 inch Mower Deck
1. Mower deck
2. Bolt
3. Spacer
5. In certain mowing conditions and terrain, a mismatch
of cutting height may be seen. Adjusting the outside
anti-scalp rollers to the minimum setting of 3/8 inch
(10 mm) will help prevent the mower deck cutting too
low on the outside and minimize the mismatch.

Adjusting the Handle Height

The handle position can be adjusted to match the operator's
height preference.
1. Remove the hairpin cotter, washer and clevis pin
securing control rod fitting to the idler bracket
(Figure 17).
1. Control rod and fitting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch) and
the flange nut securing the handle to the rear frame
(Figure 18).
17
Figure 16
4. Anti-scalp rollers
5. Nut
Figure 17
4. Washer
5. Hairpin cotter
6. Rod fitting