Resetting The Remote Controller - Onkyo HT S3200 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is
connected with an
analog audio cable (RCA).
See page 34 for details.
2
Enter the appropriate remote control code
to the REMOTE MODE button.
• [DVD/BD] button
31612: Onkyo DVD player with
• [CD] button
71327: Onkyo CD player with
• [TV/TAPE] button
42157: Onkyo cassette recorder with
(default)
• [DOCK] button
81993: Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3
Press the REMOTE MODE button, point
the remote controller at the AV receiver,
and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via
the following remote control codes:
• [DVD/BD] button
30627: Onkyo DVD player without
32900: Onkyo BD player without
• [CD] button
71817: Onkyo CD player without
• [DOCK] button
82990: Onkyo RI Dock without
Note:
If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE
IN/OUT jacks, or connect an RI Dock to the CBL/SAT
IN or VCR/DVR IN jacks, for
must set the Input Display accordingly (see page 37).
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default
remote control code.
are
cable and an
(default)
You can reset the remote controller to its default settings.
, use
(default)
(default)
(default)
to work properly, you
1 While holding down the REMOTE
MODE button that you want to
reset, press and hold down the
[AUDIO] button until the Remote
indicator lights up (about 3
seconds).
(3 seconds)
2
Within 30 seconds, press the
REMOTE MODE button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the REMOTE MODE buttons
is preprogrammed with a remote
control code. When a button is reset, its
preprogrammed code is restored.

Resetting the Remote Controller

1
While holding down the
[RECEIVER] button, press and
hold down the [AUDIO] button
until the Remote indicator lights
up (about 3 seconds).
(3 seconds)
2
Within 30 seconds, press the
[RECEIVER] button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
61