Using Headphones; Displaying Source Information - Onkyo HT S3200 Instruction Manual

Basic Operations—Continued
7

Using Headphones

For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV receiver's
PHONES jack.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off.
• Speaker sets A and B are turned off while the
headphones plug is inserted in the PHONES jack.
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it's already set to Mono,
Stereo, or Direct, in which case it stays the same.
Adjusting the Bass & Treble
You can adjust the bass or treble for speaker set A's front
speakers, except when the Direct listening mode is
selected.
AV receiver Press the [TONE] button
repeatedly to select either
"Bass" or "Treble".
Use the TONE [–]/[+] buttons to
adjust.
Remote Tip:
controller
This procedure can also be performed
on the remote controller by using
[AUDIO] button (see page 58).
■ Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■ Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
40

Displaying Source Information

You can display various information about the current
input source as follows.
Press the [RECEIVER] button,
and then press the [DISPLAY]
button repeatedly to cycle
through the available
information.
Note:
This procedure can also be performed on the AV receiver
by using its [DISPLAY] button.
The following information can typically be displayed:
Input source &
*1
volume
*2
Signal format
or sampling
frequency
Input source &
listening mode
*1 When AM or FM radio is used, the band, preset number, and
frequency are displayed.
*2 If the input signal is analog, or AM or FM radio is selected, no
format information is displayed. If the input signal is PCM, the
sampling frequency is displayed. If the input signal is digital but
not PCM, the signal format is displayed. Information is
displayed for about 3 seconds, then the previous display
reappears.
Interpreting Surround Channel Information
A B C
A: The number of front channels (front left, front
right, and center).
B: The number of surround channels (surround left
and surround right).
C: LFE channel for subwoofer (1 means yes).