Remote Control Codes For Onkyo Components Connected Via; Resetting Remote Mode Buttons; Resetting The Remote Controller - Onkyo HT-R550 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is con-
nected with an
audio cable (RCA).
See page 35 for details.
2
Enter the appropriate remote control code
for the [DVD] or [CD] REMOTE MODE but-
ton.
[DVD] REMOTE MODE button
1612: Onkyo DVD player with
[CD/MD/CDR/DOCK] REMOTE MODE button
1327: Onkyo CD player with
1808: Onkyo MD recorder with
1322: Onkyo CD recorder with
1993: Onkyo RI Dock with
See the previous page for how to enter remote
control codes.
3
Press the [DVD] or [CD] REMOTE MODE
button, point the remote controller at the
AV receiver, and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via
the following remote control codes:
• [DVD] REMOTE MODE button
0627: Onkyo DVD player without
• [CD/MD/CDR/DOCK] REMOTE MODE button
1817: Onkyo CD player without
0868: Onkyo MD recorder without
1323: Onkyo CD recorder without
2990: Onkyo RI Dock without
Note:
If you connect an -capable Onkyo MD recorder, CD
recorder, or RI Dock component to the TAPE IN/OUT or
CBL/SAT jacks, for remote operation to work properly,
you must set the Input Display to MD, CDR, or DOCK
(see page 41).
are con-
cable and an analog
, use
(default)
(default)

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default
remote control code.
1
While holding down the REMOTE
MODE button that you want to
REMOTE MODE
reset, press the [L NIGHT] button
DVD
for 3 seconds.
M D/CDR
The REMOTE MODE button lights up.
C D
DOCK
T V
VCR
CABLE
SAT
L NIGHT
2 Press the REMOTE MODE button
again.
REMOTE MODE
The REMOTE MODE button flashes
DVD
twice, indicating that it's been reset.
M D/CDR
C D
DOCK
T V
The [DVD] and [CD] REMOTE
MODE buttons are preprogrammed
VCR
with remote control codes for control-
ling Onkyo DVD players and CD play-
CABLE
SAT
ers respectively. When these buttons
are reset, the preprogrammed code is
restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down the
RECEIVER
[RECEIVER] REMOTE MODE but-
ton, press the [L NIGHT] button
for 3 seconds.
The [RECEIVER] button lights up.
L NIGHT
2
Press the [RECEIVER] REMOTE
MODE button again.
RECEIVER
The [RECEIVER] button flashes twice,
indicating that it's been reset.
63