Basic Operations - Onkyo HT S3200 Instruction Manual

Basic Operations—Continued
Using the Music Optimizer
The Music Optimizer function enhances the sound
quality of compressed music files. Use it with music files
that use "lossy" compression, such as MP3.
To turn the Music Optimizer "On"
or "Off", use the AV receiver's
[MUSIC OPTIMIZER] button.
Off: Music Optimizer off (default).
On: Music Optimizer on.
Tip:
This procedure can also be performed
on the remote controller by using
[AUDIO] button (see page 59).
Note:
The Music Optimizer function only works with PCM
digital audio input signals with a sampling rate below
48 kHz and analog audio input signals. The Music Opti-
mizer is disabled when the Direct listening mode is
selected.
Specifying the Digital Signal Format
The following table shows the display indicator for each
digital signal format.
Format Display
Dolby Digital
DTS
PCM
PCM
Normally, the AV receiver detects the format of digital
input signals automatically. However, if you experience
either of the following issues when playing PCM or DTS
sources, you can specify the signal format manually.
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or
rewinding a DTS CD, try the DTS setting.
1
Press and hold [AUDIO] button
for about 8 seconds.
2 While "Auto" is displayed (about
3 seconds), use the Left and
Right [ ]/[ ] buttons to select:
PCM, DTS, or Auto.
PCM:
Only 2-channel PCM format input
signals will be heard. If the input
signal is not PCM, the PCM
indicator will flash and there will be
no sound.
DTS:
Only DTS format input signals will
be heard. If the input signal is not
DTS, the DTS indicator will flash
and there will be no sound.
Auto (default):
The format is detected
automatically. If no digital input
signal is present, the corresponding
analog input is used instead.
,
AUDIO
41