Basic Operations; Basic Av Receiver Operation - Onkyo 29344937 Instruction Manual

Basic Operations

Basic AV receiver Operation

Input selector
1
Remote
AV receiver
controller
2
3
Remote
AV receiver
controller
MASTER VOLUME
4
MASTER VOLUME
Use the AV receiver's input selector buttons to select an input source.
To select an input source with the remote controller, press its
[RECEIVER] button, and then use its INPUT SELECTOR buttons.
Start playback on the source component.
To watch a BD, DVD, or other video source, on your TV, select the video input that's
connected to the AV receiver's COMPONENT VIDEO OUT, HDMI OUT, or
MONITOR OUT.
On some DVD players, you may need to change the digital or HDMI audio output
settings.
To adjust the volume, use the MASTER VOLUME control or the remote
controller's VOL [q]/[w] button.
Since the AV receiver is designed for home theaters, it has a wide volume range for
precise adjustment. The volume can be set to Min, 1 through 79, or Max.
To set the level of the subwoofer, use the OUTPUT LEVEL control.
Because our ears are less sensitive to very low bass sounds, there's a temptation to set
the level of the subwoofer too high. As a rule of thumb, set the subwoofer level to
what you think is the optimal level, and then back it off slightly.
Select a listening mode and enjoy!
See "Using the Listening Modes" on page 61.
Subwoofer's
INPUT
rear panel
SELECTOR
RECEIVER
VOL q, w
MAX
MIN
OUTPUT LEVEL
OUTPUT
LEVEL
control
49