Cutting A Hole And Mounting Installation Plate - Samsung ASH-0906ER Service Manual

Operating Instructions and Installation
3-2-2(a) Cutting a hole and mounting installation plate
CUTTING A HOLE
Installation plate
123.5mm
MOUNTING THE INSTALLATION PLATE
● When the installation plate is directly
mounted on the wall.
400mm
Pipe hole
(∅65mm)
Weight
123.5mm
indoor unit
228.5mm
● Mounting at the window frame
Screw wood
3-2-2(b) Wiring connection (indoor unit)
Screw
3-6
Pipe hole(∅65mm)
37mm
Anchor bolt
450mm
installation plate
123.5mm
258.5mm
cutting part
410¡›730mm
410�730mm
Wood pillar
1. Open the Grille and remove the screw securing
the cover.
2. Firmly connect the cable connector with EL-
connector. (3pin)
3. Assembly every parts by contrary order to
disassembly.
Determine the pipe hole position using
the paper pattern for installation and
drill the pipe hole (65mm inner
diameter) so that it slants slightly
downward.
1. Separate the cutting part of the
installation plate before installing the
installation plate.
2. Install the installation plate
horizontally on structural members
(studs, etc) in the wall.
3. To mount the installation plate on a
20mm
or less concrete wall with anchor bolts, utilize
the anchor bolt holes as illustrated in
the left figure.
4. When the anchor bolts are already
driven in the wall, also utilize the
anchor bolts holes to secure the
installation plate.(If an anchor bolt is
too long, adjust the projecting length to
20mm or less.)
1. When mounting installation-plate at
the window frame.
Use the paper patten for installation of
the wood pillar.
2. As the left Fig.
Fix the wood pillar at the wood frame
and install installation-plate with
screw-tap.
3. Fix the wood pillar with enough
strength to bear the weight of the
indoor unit.
Samsung Electronics