Onkyo TX-SR707 Instruction Manual page 60

Basic Operations—Continued
Changing Source Component
When you want to operate the component that is not
assigned as the source component, you can assign it as
the source component.
While holding down the REMOTE
MODE button, press and hold
down the [MY MOVIE], [MY TV],
or [MY MUSIC] button (about 3
seconds).
The ACTIVITIES buttons that you
pressed flashes twice, indicating that
the setting has been established.
Examples:
When you press the [MY MUSIC] but-
ton and want to start the Onkyo Cas-
sette recorder, while holding down
[TV/TAPE] button, press and hold
down the [MY MUSIC] button (about
(3 seconds)
3 seconds) flashes twice.
Switching Normal Macro Mode
You can switch the AV receiver to normal macro mode
from Easy macro mode, and vice versa. In the normal
macro mode, you can use macro commands (see
page 120).
While holding down the
[RECEIVER] button, press and
hold down the ACTIVITIES but-
tons (about 3 seconds).
Note:
Once the AV receiver has entered the
normal macro mode, all of the ACTIV-
ITIES buttons will automatically
switch to the Normal macro mode. In
this case, pressing the [ALL OFF] but-
(3 seconds)
ton will only set the AV receiver to
Standby mode.
60
Restoring Default
1
While holding down the [AUDIO]
button, press and hold down the
[ALL OFF] button until the [ALL
OFF] button lights up (about 3
seconds).
(3 seconds)
2 Release the [AUDIO] and [ALL
OFF] buttons and press the [ALL
OFF] button again.
The [ALL OFF] button flashes twice.