Checking The Wiring And Fasteners; Test Driving The Tractor - Toro 73551 Setup Instructions

Set-Up Instructions
Checking the Wiring and
Fasteners
Inspect the tractor for any loose electrical
connections and secure them as required. Check
the wire routing to make sure moving parts do
not interfere with wires and cause a short.
Assure all fasteners are tight.
Burnishing the Clutch
The following break–in procedure must be performed
as part of predelivery service or when a new clutch is
installed.
Note: There must be a PTO driven
attachment installed to provide a load
in order to burnish the clutch facings
properly.
1. Run the engine at full throttle and engage the
clutch bringing the load to full speed. Then
disengage the clutch.
2. Let the load come to a full stop, then engage
again.
3. Repeat these procedures (1 and 2) 5 times.

Test Driving the Tractor

1. Check the oil level in the crankcase (refer to
Engine Oil in your tractor Operator's Manual for
oil type, viscosity and crankcase capacity).
2. Check the oil level in the transaxle (refer to
Transaxle Fluid in your tractor Operator's
Manual for oil type, viscosity and capacity).
3. Check that the coolant level is between the two
lines on the coolant recovery tank when the
engine is cold (refer to Check the Cooling
System in your tractor Operator's Manual).
8
4. Make sure all water is drained from the fuel filter
(refer to Draining Water From The Fuel
Filter/Water Separator in your tractor Operator's
Manual).
5. Check to make sure all lubrication points have
been greased as shown in the Maintenance
section of tractor Operator's Manual.
6. Fill the tank with fresh diesel fuel with a
minimum cetane rating of 40 and the proper
grade for the ambient temperature conditions
(refer to Adding Fuel in your tractor Operator's
Manual) Open the fuel shutoff valve and check
the fuel hose and fittings for leaks.
7. As applicable, check and test the operation of the
following:
Engine and throttle controls
Gauges
Headlights and taillights
Indicator lights
PTO clutch and brake
Lift system
Service and parking brakes
Transmission controls
Steering
Tractor operation in forward and reverse
8. Test the operation of the safety interlock system
(refer to the tractor Operator's Manual for the
correct procedure).