Advertisement

Quick Links

Loose Parts

Note:
Use the chart below to identify parts for assembly.
DESCRIPTION
Steering Wheel
Boot Washer
Nut
Lock Washer
Trim Cover
Seat Assembly
Shoulder Bolt – 5/16"
Locknut – 5/16"
Hitch Pin
Hairpin Cotter
Flat Washer – .50" I.D.
Key
Operator's Manual
Engine Operator's Manual
Riding Mower Safety Video
"Thank You" Card
Printed in USA
523Dxi GARDEN TRACTOR
MODEL NO. 73552–9900001 & UP
QTY.
1
1
1
1
1
1
2
2
1
1
1
2
1
1
1
1
The Toro Company – 1999
All Rights Reserved
INSTRUCTIONS
USE
Installing the steering wheel
Installing the seat
Installing the drawbar hitch pin
Use in ignition and "Key Choice" switches
Read before operating the tractor
Read before operating the tractor
Attach to the tractor
Read
FORM NO. 3321–970
SET UP

Advertisement

Table of Contents
loading

Summary of Contents for Toro 73552

  • Page 1: Loose Parts

    FORM NO. 3321–970 523Dxi GARDEN TRACTOR SET UP MODEL NO. 73552–9900001 & UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Steering Wheel Boot Washer Installing the steering wheel Lock Washer Trim Cover Seat Assembly Shoulder Bolt –...
  • Page 2: Installing The Seat

    Set-Up Instructions Installing the Seat Note: There is no fixed straight ahead position on power steering models. Mount the seat to the seat base using two 5/16” Secure the steering wheel to the shaft with a lock shoulder bolts and lock nuts (Fig. 1). washer and nut (Fig.
  • Page 3: Activating The Battery

    Set-Up Instructions Check to Insure that Steering Activating the Battery Linkage is Centered With the tractor on a level surface, turn the steering wheel fully to the left and check the POTENTIAL HAZARD clearance of the left hand spindle stop to the stop Battery electrolyte contains sulfuric acid on the front axle.
  • Page 4 Set-Up Instructions When the battery is fully charged, unplug the charger from electrical outlet, then disconnect the charger leads from the battery posts (Fig. 5). m–3799 Figure 4 1. Cell cover 3. Lower part of tube 2. Electrolyte m–3798 Figure 5 1.
  • Page 5: Installing The Drawbar Hitch Pin

    Set-Up Instructions Installing the Drawbar Hitch Burnishing the Clutch The following break–in procedure must be performed as part of predelivery service or when a new clutch is Insert the drawbar hitch pin into the drawbar hitch installed. and secure it with a .50” I.D. flat washer and hairpin cotter (Fig.
  • Page 6: Test Driving The Tractor

    Set-Up Instructions Test Driving the Tractor As applicable, check and test the operation of the following: Check the oil level in the crankcase (refer to Engine and throttle controls Engine Oil in your tractor Operator’s Manual for oil type, viscosity and crankcase capacity). Gauges Check the oil level in the transaxle (refer to Headlights and taillights...

Table of Contents