Installing The Drawbar Hitch Pin; Test Driving The Tractor; Checking The Wiring And Fasteners - Toro 73570 Setup Instructions

10. After servicing the battery, replace the front grill of the
tractor and secure the grill with two #8 x .50" long
grill screws and .75" O.D. grill washers in the upper
two grill mounting holes (Fig. 11).
1
Figure 11
1. Grill screw (1 of 2)
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch and
secure it with a 0.50 in. I.D. flat washer and hairpin cotter
(Fig. 12).
2
4
Figure 12
1. Drawbar hitch pin
2. Drawbar hitch
Checking the Wiring and
Fasteners
Inspect the tractor for any loose electrical connections
and secure them as required.
Check the wire routing to make sure moving parts do
not interfere with wires and cause a short.
Ensure all fasteners are tight.
2
m–3558
2. Grill washer (1 of 2)
1
3
m–2481
3. Flat washer, 0.50 in. I.D.
4. Hairpin cotter

Test Driving the Tractor

1. Check the oil level in the crankcase (refer to the
Operator's Manual for oil type, viscosity and
crankcase capacity).
2. Check the oil level in the transaxle (refer to the
Operator's Manual for oil type, viscosity and
capacity).
3. Check the coolant level in the coolant recovery tank.
4. Ensure that all lubrication points have been greased as
shown in the Maintenance section of tractor Operator's
Manual.
5. Fill the tank with unleaded regular gasoline with an
octane rating of at least 85.
6. Open the fuel shutoff valve and check the fuel hose
and fittings for leaks.
7. As applicable, check and test the operation of the
following:
Engine, choke and throttle controls
Gauges
Headlights and taillights
Indicator lights
PTO clutch and brake
Lift system
Service and parking brakes
Transmission controls
Steering
Tractor operation in forward and reverse
8. Test the operation of the safety interlock system (refer
to the Operator's Manual for the correct procedure).
6