Installing The Rear Wheels; Installing The Front Wheels - Toro 73551 Setup Instructions

Set-Up Instructions
DESCRIPTION
Bolt – 1/4"-20 x .75" Long
Wing Nut – 1/4"-20
Grill Screw – #8 x .50" Long
Grill Washer – .75" O.D.
Hitch Pin
Hairpin Cotter
Flat Washer – .50" I.D.
Key
Operator's Manual
Engine Operator's Manual

Installing the Rear Wheels

1. Remove the four wheel bolts holding the rear
shipping brackets to the rear hubs.
2. Using a jack or suitable hoist, raise the rear of
the tractor only high enough to install the rear
wheels.
3. Install the wheels onto the hubs with the valve
stems facing inward (Fig. 1).
4. Tighten the wheel bolts to 75–80 ft-lb
(105–112 N m).
1
Figure 1
1. Hub
2. Rear wheel
2
QTY.
2
3
m–1278
3. Wheel bolt (5)
2
Attaching the battery cables
2
2
Securing the grill
2
1
1 Installing the drawbar hitch pin
2
1 Use in ignition switch
1 Read before operating the tractor
1 Read before operating the tractor

Installing the Front Wheels

IMPORTANT: Never raise the front of the
tractor by placing a jack under the bumper
or front axle because the tractor may be
damaged.
1. The front hood support braces have two slots
(Fig. 2) that may be used to lift the tractor to
install the front wheel spindles. To access these
slots, remove the front grill and raise the hood.
2
1
Figure 2
1. Slots
Note: Remove, or be careful not to damage,
the two upper grill grommets (Fig. 2).
USE
2
m–3454
2. Grill Grommets
1