Installing The Drawbar Hitch Pin - Toro 73551 Setup Instructions

4. When the battery is fully charged, unplug the
charger from electrical outlet, then disconnect
the charger leads from the battery posts
(Fig. 10).
4
2
Figure 10
1. Positive battery post
2. Negative battery post
5. Slowly pour electrolyte into each cell until the
level is once again up to the lower part of the
tube (Fig. 9), then install the cell cover.
6. Install the battery in the tractor and connect the
battery cables (refer to Installing the Battery in
your tractor Operator's Manual).
Note: Do not run the tractor with the battery
disconnected.
3
1
m–3798
3. Red (+) charger lead
4. Black (–) charger lead
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a .50" I.D. flat washer and hairpin
cotter (Fig. 11).
2
4
Figure 11
1. Drawbar hitch pin
2. Drawbar hitch
Set-Up Instructions
1
3
m–2481
3. .50" Flat washer
4. Hairpin cotter
7