FORM NO. 3321–967 520Lxi GARDEN TRACTOR SET UP MODEL NO. 73547–9900001 & UP INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. DESCRIPTION QTY. Seat Assembly Shoulder Bolt – 5/16” Installing the seat Locknut – 5/16”...
Set-Up Instructions Installing the Seat Install the steering wheel onto the shaft, carefully aligning the splines (Fig. 2). Mount the seat to the seat base using two 5/16” Note: There is no fixed straight ahead shoulder bolts and lock nuts (Fig. 1). position on power steering models.
Set-Up Instructions Check to Insure that the Checking Tire Pressure Steering Linkage is Centered Check front and rear tire pressure. The correct front and rear tire pressure is 20 psi (138 kPa). With the tractor on a level surface, turn the steering wheel fully to the left and check the clearance of the left hand spindle stop to the stop Activating the Battery...
Page 4
Set-Up Instructions 1262 Figure 4 1. Filler caps 3. Lower part of tube 2. Electrolyte 1254 Figure 5 1. Positive battery post 3. Red (+) charger lead 2. Negative battery post 4. Black (–) charger lead POTENTIAL HAZARD Slowly pour electrolyte into each cell until the Charging battery produces gasses.
Set-Up Instructions Repeat these procedures (1 and 2) 5 times. Test Driving the Tractor Check the oil level in the crankcase (refer to Engine Oil in your tractor Operator’s Manual for oil type, viscosity and crankcase capacity). Check the oil level in the transaxle (refer to Transaxle Fluid in your tractor Operator’s Manual for oil type, viscosity and capacity).