Starting And Stopping The Engine - Toro 74840 Operator's Manual

Starting and Stopping the
Engine
Starting the Engine
1
3
5
Figure 19
1. Sit down on the seat (Figure 19).
2. Move the motion controls outward to the neutral
lock position (Figure 19).
3. Set the parking brake (Figure 19); refer to Setting
the Parking Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 19).
5. If starting a cold engine, Pull up on the choke knob
to engage the choke.
Note: A warm or hot engine may not require
choking.
6. Turn the ignition key to the Start position
(Figure 18). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
2
4
G010080
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
1. Off
2. Run
Stopping the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
22
G008947
Figure 20
3. Start