Changing The Oil - Toro 74408TE Operator's Manual

Figure 30
Checking the Engine Oil Level
1. Park the machine on a level surface.
2. Disengage the PTO, turn the ignition key to
off, and remove the key.
3. Wait for all moving parts to stop before leaving
the operating position and then chock or block
tires.
4. Clean around the oil dipstick (Figure 31) so
that dirt cannot fall into the filler hole and
damage the engine.
Figure 31
1. Oil dipstick
5. Unscrew the oil dipstick and wipe the end
clean (Figure 31).
6. Slide the oil dipstick fully into the filler tube,
but do not thread onto tube (Figure 31).
7. Pull the dipstick out and look at the end. If the
oil level is low, slowly pour only enough oil into
the filler tube to raise the level to the Full mark.
2. Filler tube
Important: Do not overfill the crankcase
with oil and run the engine; engine damage
can result.

Changing the Oil

1. Start the engine and let it run five minutes.
This warms the oil so it drains better.
2. Park the machine so that the drain side is
slightly lower than the opposite side to assure
the oil drains completely.
3. Disengage the PTO and set the parking brake.
4. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
5. Slide the drain hose over the oil drain valve.
6. Place a pan below the drain hose. Rotate oil
drain valve to allow oil to drain (Figure 32).
7. When oil has drained completely, close the
drain valve.
8. Remove the drain hose (Figure 32).
Note: Dispose of the used oil at a recycling
center.
Figure 32
1. Oil drain valve
9. Slowly pour approximately 80% of the
specified oil into the filler tube (Figure 31).
10. Check the oil level; refer to Checking the
Engine Oil Level.
11. Slowly add the additional oil to bring it to the
Full mark.
31
2. Oil drain hose