Servicing The Engine Oil - Toro 74408TE Operator's Manual

With a 86cm 7-gauge side discharge mower or with a 102cm 7-gauge side discharge mower

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

5. Remove the 2 wing nuts and remove the air

cleaner assembly (Figure 29).

6. Carefully pull the foam element off the paper

element (Figure 29).

Figure 29

1. Engine

2. Cover

3. Wing nut

Cleaning the Foam Air Cleaner

Element

1. Wash the foam element in liquid soap and

warm water. When the element is clean, rinse

it thoroughly.

2. Dry the element by squeezing it in a clean

cloth.

Important: Replace the foam element

if it is torn or worn.

Servicing the Paper Air Cleaner

Element

1. Do not clean the paper ﬁlter. Replace it after

200 operating hours (Figure 29).

4. Foam element

5. Paper element

6. Cover knob

2. Inspect the element for tears, an oily ﬁlm, or

damage to the rubber seal.

3. Replace the paper element if it is damaged.

Installing the Foam and Paper

Elements

Important: To prevent engine damage,

always operate the engine with the complete

foam and paper air cleaner assembly installed.

1. Carefully slide the foam element onto the

paper air cleaner element (Figure 29).

2. Place the air cleaner assembly onto the air

cleaner base and secure it with the 2 wing nuts

(Figure 29).

3. Place the air cleaner cover into position and

tighten the cover knob (Figure 29).