Controls System Maintenance; Adjusting The Control Handle; Neutral Position; Adjusting The Tracking - Toro 74408TE Operator's Manual

Figure 47
1. Transmission pump pulleys 3. Engine pulley
2. Pump drive belt
9. Install the seat retainer bracket.
Controls System
Maintenance
Adjusting the Control
Handle Neutral Position
1. Disengage the PTO, move the motion control
levers to the neutral locked position, and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. Loosen the bolts and curved washers installed
in the levers (Figure 48).
4. Align the levers front to rear position by bring
the levers together to the neutral position and
slide them until they are aligned, then tighten
the bolts (Figure 49).
4. Spring loaded idler pulley
Figure 48
Figure 49
5. If the ends of the levers hit against each other,
adjust the levers by rotating them out to the
neutral locked position and carefully bend
them outward. Repeat this step as needed.

Adjusting the Tracking

1. If the machine turns right or left when the
handles are pushed forward together, adjust
the stop on the side opposite that the machine
turns.
40