Storage - Toro 74408TE Operator's Manual

Storage

1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to Off.
Remove the key.
2. Remove grass clippings, dirt, and grime from
the external parts of the entire machine,
especially the engine and hydraulic system.
Clean dirt and chaff from the outside of the
engine cylinder head fins and blower housing.
Important: You can wash the machine
with mild detergent and water. Do
not pressure wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps,
and motors.
3. Service the air cleaner; refer to Servicing the
Air Cleaner in Engine Maintenance, page 29.
4. Grease the machine; refer to Greasing and
Lubrication in Lubrication, page 27.
5. Change the crankcase oil; refer to Servicing the
Engine Oil in Engine Maintenance, page 29.
6. Check the tire pressure; refer to Checking the
Tire Pressure in Drive System Maintenance,
page 37.
7. Change the hydraulic filter; refer to
Servicing the Hydraulic System in
Hydraulic System Maintenance, page 41.
8. Charge the battery; refer to Servicing the
Battery in Electrical System Maintenance,
page 34.
9. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash
the mower with a garden hose.
Note: Run the machine with the PTO
engaged and the engine at high idle for 2 to
5 minutes after washing.
10. Check the condition of the blades;
refer to Servicing the Cutting Blades in
Mower Deck Maintenance, page 43.
11. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A. Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol based stabilizer (ethanol or
methanol).
Note: A fuel stabilizer/conditioner is
most effective when mixed with fresh fuel
and used at all times.
B. Run the engine to distribute conditioned
fuel through the fuel system (5 minutes).
C. Stop the engine, allow it to cool, and drain
the fuel tank; refer to Servicing the Fuel
Tank in Fuel System Maintenance, page 33.
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per
local codes.
Important: Do not store
stabilizer/conditioned fuel over
90 days.
12. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
13. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
14. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it out of reach of children or
other unauthorized users. Cover the machine
to protect it and keep it clean.
50