Hydraulic System Maintenance; Servicing The Hydraulic; System - Toro 74408TE Operator's Manual

2. Loosen the bolt located in front of the control
lever.
3. Move the stop until the machine drives straight
(Figure 50).
4. Tighten the bolt located in front of the control
lever (Figure 50).
Figure 50
1. Control lever
2. Stop
Hydraulic System
Maintenance

Servicing the Hydraulic

System

Checking the Hydraulic Fluid
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important: Use oil specified or equivalent.
Other fluids could cause system damage.
Check the hydraulic fluid level:
• Before the engine is first started.
3. Bolt in front of the control
lever
• After the first 8 operating hours.
• After every 50 operating hours.
Note: There are two ways of checking the
hydraulic oil; when the oil is warm or when the oil
is cold. The tank has two levels depending if the
oil is warm or cold (Figure 51).
1. Position the machine on a level surface and set
the parking brake.
2. Clean the area around the hydraulic tank
(Figure 51).
3. If the machine has not been started and is cold,
ensure the fluid is up to the cold line on the
side of the hydraulic tank.
4. If the machine has been run and is up to
normal operating temperature, ensure the fluid
is up to the hot line on the side of the hydraulic
tank.
5. If fluid is needed, remove the cap from the
filler neck (Figure 51).
6. Add fluid to the reservoir until it reaches the
cold or hot line of the tank depending on the
temperature of the fluid.
7. Install the cap on filler neck.
Figure 51
1. Cap
2. Hot uid level-full
41
3. Cold uid level-full