Cooling System Maintenance; Servicing The Engine Cooling System - Toro 30856 Operator's Manual

5. Rotate the entire tie rod assembly the same direction
(inward or outward) one (1) complete revolution.
Tighten clamp at connected end of tie rod.
6. Install the ball joint in the axle case support and
tighten the nut finger tight. Measure toe-in.
7. Repeat procedure if necessary.
8. Tighten the nut and install a new cotter pin when
the adjustment is correct.
Cooling System
Maintenance
Servicing the Engine Cooling
System
Service Interval: Before each use or daily
Remove debris from the engine area, oil cooler and
radiator daily. Clean them more frequently in dirty
conditions.
1. Unlatch and swing open rear screen (Figure 51).
Clean the screen thoroughly of all debris.
Note: To remove screen, lift off hinge pins.
1. Rear screen latch
2. Rotate latches (Figure 52) securing the oil cooler to
the frame.
1. Oil cooler latches
3. Pivot the oil cooler rearward. Clean both sides of the
oil cooler and radiator area (Figure 53) thoroughly
42
Figure 51
Figure 52