Operation; Checking The Engine Oil Level; Checking The Cooling System - Toro 30856 Operator's Manual

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.
This machine produces sound levels in excess
of 85 dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do
any maintenance.

Checking the Engine Oil Level

Service Interval: Before each use or daily
The engine is shipped with oil in the crankcase;
however, the oil level must be checked before the
engine is first started.
The crankcase capacity is approximately 8 qt. (7.6 l)
with the filter.
Use high-quality engine oil that meets the following
specifications:
• API Classification Level Required: CH-4, CI-4 or
higher.
• Preferred oil: SAE 15W-40 (above 0°F)
• Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Note: Toro Premium Engine oil is available
from your distributor in either 15W-40 or 10W-30
viscosity. See the parts catalog for part numbers.
1. Park the machine on a level surface.
2. Unlock the engine cover latches and open the
engine cover.
3. Remove the dipstick, wipe it clean, install the
dipstick into the tube, and pull it out again.
The oil level should be up to the FULL mark
(Figure 13).
1. Dipstick
4. If the oil is below the FULL mark, remove the fill
cap (Figure 14) and add oil until the level reaches
the FULL mark. Do not overfill.
1. Oil fill cap
Note: When using different oil, drain all old oil
from the crankcase before adding new oil.
5. Install the oil fill cap and dipstick.
6. Close the engine cover and secure it with the latches.

Checking the Cooling System

Service Interval: Before each use or daily
Check level of coolant at the beginning of each day.
Capacity of system is 2-3/4 gal. (10.4 l).
1. Carefully remove the radiator cap and expansion
tank cap (Figure 15).
20
Figure 13
Figure 14