Pto Switch; Fuel Gauge; Lift Lever; Hour Meter - Toro 30856 Operator's Manual

Model 4500-D
1. Throttle control

2. Lift lever

3. Hour meter

4. Engine temperature gauge

Model 4700-D
1. Throttle control
2. Lift lever
3. Hour meter
4. Engine temperature gauge
Lift Lever
The lever (Figure 8) raises and lowers the cutting units.
Hour Meter
The hour meter (Figure 8) shows the total hours that the
machine has been operated.
Engine Temperature Gauge
This gauge (Figure 8) indicates the engine coolant
temperature.
Figure 8

5. PTO switch

6. Hi-Lo speed control
7. Power point
Figure 9
5. PTO switch
6. Hi-Lo speed control
7. Power point
PTO Switch
The PTO switch (Figure 8) has two positions: On
(engage) and Off (disengage). Push the PTO switch
forward to the On position to start the implement or
cutting unit blades. Push the switch backward to the Off
position to stop implement operation.
Hi-Lo Speed Control
The switch (Figure 8) allows the speed range to increase
for transport of the machine. Cutting decks will not
operate in high range.
Power Point
The power point (Figure 8) is used to power optional 12
volt electrical accessories.

Fuel Gauge

The fuel gauge (Figure 10) indicates the level of fuel in
the tank.
1. Fuel gauge
Cutting Unit Lift Latch (CE)
The cutting unit lift latch (Figure 11 or Figure 12) locks
the center five cutting unit lift levers when the cutting
units are in the raised position.
17
Figure 10