Setup; Installing The Seat, Seat Belt, And Manual Tube - Toro 30856 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note: Determine the left and right sides of the machine from the normal operating position.
1
Installing the Seat, Seat Belt,
and Manual Tube
Parts needed for this procedure:
1 Seat Kit, Model 30398 (sold separately)
Seat Suspension Kit, Model 30312 (Mechanical) or
1
30313 (Air) (sold separately)
1 Seat belt
2 Capscrew, 7/16-20 x 1 inch
2
Lockwasher, 7/16 inch
1 Manual Tube
2 R-clamp
Procedure
The machine is shipped without the seat assembly.
Deluxe Seat Kit, Model No. 30398, and Seat Suspension
Description
Seat Kit, Model 30398 (sold separately)
Seat Suspension Kit, Model 30312
(Mechanical) or 30313 (Air) (sold
separately)
Seat belt
Capscrew, 7/16-20 x 1 inch
Lockwasher, 7/16 inch
Manual Tube
R-clamp
Warning Decal
No parts required
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Pre-delivery Inspection Sheet
Qty.
1
1
Install the seat, seat belt, and manual
1
tube.
2
2
1
2
Used only on machines outside the
1
U.S.A.
–
Grease the machine.
Check the rear axle lubricant, hydraulic
–
fluid, and engine oil levels
1
1
Read the manuals and watch the
1 training material before operating the
machine.
1
1
Kit, Model No. 30312 or 30313, must be purchased and
installed.
1. Mount the manual tube to the seat suspension with
the 2 R-clamps included in loose parts (Figure 3).
2. Install the seat belt to each side of the seat with a bolt
and lock washer, supplied in loose parts (Figure 3).
The seat belt retractor is to be mounted to the right
side of the seat and the seat belt buckle to the left
side.
Important: Make sure that the seat switch is
connected to the seat switch connector on the
harness.
13
Use