Rear Panel - Onkyo A-933 Instruction Manual

*En_A933_02.fm Page 7 Tuesday, January 25, 2005 1:46 PM
Front & Rear Panels —Continued

Rear Panel

1 2
GND
PHONO (MM)
SUBWOOFER
PREOUT
MAIN IN
0 A
A
Grounding terminal
This terminal is for connecting a turntable's ground
wire.
B
PHONO (MM) input
This analog audio input is for connecting a turntable
with a moving-magnet cartridge.
C
TUNER input
This analog audio input is for connecting a tuner's
analog audio output.
D
CD input
This analog audio input is for connecting a CD
player's analog audio output.
E
LINE input
This analog audio input is for connecting a compo-
nent's analog audio output (TV, etc).
F
REMOTE CONTROL jacks
These (Remote Interactive) jacks can be con-
nected to the jacks on your other Onkyo audio
components. The A-933's remote controller can
then be used to control all of your components. To
use , you must make an analog audio connection
between the A-933 and each component.
G
SPEAKERS B
These terminal posts are for connecting speaker set
B.
H
SPEAKERS A
These terminal posts are for connecting speaker set
A.
I
AC OUTLET
This AC outlet can be used to supply power to
another audio component. The type of outlet
depends on the country in which you purchased the
A-933.
3 4 5 6 7
L
L L
B
R R
R
TUNER CD
L L L
R
R R R
REMOTE
OUT IN OUT IN
CONTROL
MD
TAPE/CDR
INTEGRATED AMPLIFIER
B C
8
SPEAKERS
A
AC OUTLET
AC 230-240 V
L R L 50 Hz
UNSWITCHED
TOTAL 100 W MAX.
CAUTION: SPEAKER IMPEDANCE
A or B : 4 OHMS MIN. /SPEAKER
A- 933 A + B : 8 OHMS MIN. /SPEAKER
MODEL NO.
J
SUBWOOFER PREOUT
This jack is for connecting a powered subwoofer.
K
MAIN IN
This analog audio input is for connecting a separate
preamp when you want to use the A-933 as a power
amplifier.
Caution:
Do not connect a component that does not have an
output volume control, such as a CD player, because
the sound will be output at maximum volume and
may damage the A-933 and your speakers.
L
MD IN/OUT
This analog audio input and output are for connect-
ing an MD recorder with an analog audio input and
output.
M
TAPE/CDR IN/OUT
This analog audio input and output are for connect-
ing a recorder (CD, cassette, etc) with an analog
audio input and output.
See pages 11–16 for connection information
9
7